How to play Tape in Canon 920 camera you mentioned is not a specific model that I am familiar with as of my knowledge cutoff in September 2021. However, Canon cameras typically have a similar method for playing tapes. Here are some general steps that may help you play a tape in a Canon camera:

  1. Make sure the camera is powered on and the tape is inserted properly into the tape compartment. Usually, there is a specific slot or door where the tape is inserted.
  2. Locate the playback mode or VCR mode on the camera. This mode allows you to play back the recorded tapes. Look for a mode dial or button labeled “VCR,” “Playback,” or a similar icon indicating playback mode.
  3. Once you have switched to the playback mode, use the camera’s controls or buttons to navigate the tape. Canon cameras often have buttons for rewinding, fast-forwarding, playing, pausing, and stopping. These buttons are typically located near the LCD screen or on the top or side of the camera.
  4. Use the playback controls to select the desired tape and start playback. Depending on the camera model, you may be able to control the playback speed or access additional features such as pause, slow motion, or frame-by-frame playback.

It’s important to note that the specific steps may vary depending on the model of the Canon camera you have. I recommend consulting the camera’s user manual or referring to Canon’s official website for detailed instructions and information specific to your camera model.


I apologize for the confusion in my previous response. Since I don’t have information on a specific Canon 920 camera, it’s possible that the model you mentioned doesn’t exist or is a rare or outdated model. However, here are some general steps you can follow to play a tape on a Canon camcorder:

  1. Ensure the camera is powered on and the tape compartment is accessible. Locate the tape compartment, which is usually on the side or back of the camera, and open it by sliding or flipping the door.
  2. Insert the tape into the compartment with the exposed tape facing outward. Gently push the tape until it is fully inserted and close the tape compartment door securely.
  3. Power on the camera if it’s not already turned on. Some Canon cameras have a dedicated power switch, while others may require you to open the LCD screen or press a specific button to activate the camera.
  4. Once the camera is powered on, switch to playback mode or VCR mode. Look for a mode dial or button that is labeled “VCR,” “Playback,” or a similar icon indicating tape playback. Refer to the camera’s user manual for specific instructions on selecting the playback mode.
  5. Use the camera’s playback controls to navigate through the tape. Typically, you can use buttons or a control dial to fast forward, rewind, play, pause, and stop the tape. These controls are usually located near the LCD screen or on the camera’s body.
  6. Adjust the volume if necessary. Some cameras have built-in speakers or headphone jacks where you can listen to the audio from the tape. Look for volume controls or settings to adjust the playback volume.

Please note that these steps are general guidelines and may not apply exactly to the Canon 920 camera you mentioned. For accurate instructions, I recommend referring to the camera’s user manual or contacting Canon’s customer support for assistance.

Read This: How to Measure Shoulder Width

Write A Comment